It can be daunting when you are thinking of replacing you garbage disposer. People always have a trepidation when it comes to water and electricity. Sink connections are unfamiliar and may make sink to leak. You may learn that it is very easy to replace your garbage disposal that is why it is important for you to know how to replace your garbage disposal. Old units should be checked to ensure that they are not jammed hence you should not buy the old units before you check how the units are. The common thing about the disposal units is that they normally jam easily hence you should check the connection of the jammed disposal. The following factors should be considered when you want to replace your jammed disposal unit.
Your electricity should be turned off. Your electricity should be turned off to ensure that your disposal unit is not connected with an electric current. When you want to work on your disposal unit, turning off your electricity is very important. The cover of the disposal unit should be removed. The cover is normally at the base of the disposal. By loosening the screw, you should remove the cover of the disposal unit this is very important.
There should loosening if the cover that cover the disposal unit. There should be removal of the hose for the fitting by loosening the hose clamp. Once the bolt is lose, you should remove the old unit. For you to remove the disposal unti you should have the ability to remove the disposal unit from below. You should rotate the disposer counterclockwise, this is the next step. This will be until the unit does fall away. You should remove the remainder of the drain by loosening all the three bolts.
The putty should be applied. Putty is applied in times that you want to install the new drain. The putty should be rolled on the counter that is 1/2 thick. You should stick the putty at the underside of the drain and firmly press towards the sink hole. When it comes to backing up the cardboard washer, you should back it up with the ring this is very important when you are finishing up the drain. The snapping ring should be mounted, this is a very important step. By retaining the snap into the drain, the drain should be drained. There should be draining of the drain by retaining the snap into the drain.
The bolts should be tightened. There should be tightening of the bolts by using the screwdriver. The drain should be snug with the sink. It is very advantageous when it comes to installing a new drain. You should wire the new disposer to make it flexible to conduct electricity. You will be assisted by this when you are upgrading the disposal. You should then finish up by bring the wires into the conductor. You will secure the conductor by this help.